Step 2. Rear Wheel Axle Assembly
Tip stroller so the belly bar is on the ground and the rear legs are up. Hold the axle with the brake levers up. Align the wheel brackets with the legs and push on wheel bracket until they lock into place on both sides (Picture D). Pull on wheels to make sure they are locked in place. In the future, if you need to remove rear axle, push tab that is located inside the wheel brackets and pull each side off (Picture E).
Step 3. Front Wheel Assembly
Turn stroller on its side. Slide the front wheel assembly onto the front fork and push until it locks in place (Picture F). Pull on wheel to make sure that it is locked in place. Repeat for other side. In the future, if you need to remove front wheels, push tab that is located on bottom of wheel assembly and pull off (Picture G).
Note: There is a lever on the wheel assembly that locks the wheels from swiveling when used as a frame carrier.
Step 4. Canopy Assembly
Turn stroller upright. Place the canopy so the rounded edge is positioned behind the headrest and snap it onto the back of headrest. Bend the canopy and snap both sides onto the belly bar (Picture H).
Congratulations - assembly is now complete!
G | Front Wheel |
|
Swivel
Lock
Lever
Front
Wheel
Removal
Tab
D | Rear |
Rear Wheel | Brake |
Axle Assembly | Levers |
Notch in
Leg Up
Notch
Rear
Legs
E | Rear Brake Lever |
Rear
Wheel
Tab for Rear
Wheel Removal
F | Dual Front |
| Wheel |
Swivel Lock
Lever
Front Leg
H
Rear
Canopy
Snap
Belly
Bar
Snap
Waist
Strap
Cover
3