Using the stroller as a Doll Car Seat Carrier
•To use the stroller to carry a doll car seat carrier, you must replace the Front Tray with the Car Seat Carrier Support.
•Remove the Front Tray by pressing in on the buttons under the female fitting and pulling the tray off the brackets.
•Line up the Car Seat Carrier Support to the metal tubing on the front of the stroller and push inward until the support snaps into place. See Figure 16. Pull outward on the support sides to be sure both are snapped securely in place.
•Adjust the backrest to its reclined position.
•If necessary, remove the infant carrier from the car seat base.
•Place the infant carrier onto the top of the stroller in a REAR FACING POSITION, locating the head end of the carrier so that it rests on the car seat support and the feet end of the carrier so that it rests against the seatback. See Figure 17.
•Insure that the infant carrier is pushed down into this position firmly and that it is centered side to side.
•Remove the carrier restraining strap from the pouches on the sides of the front seat. Buckle it in place over the LOWEST part of the carrier sides. Adjust the strap so that it is tight around the carrier. Pull up on the carrier to be sure it is held on securely. See Figure 18.
Figure 16
Figure 17
Figure 18
WARNING
ALWAYS install the doll carrier in a REAR FACING POSITION.
ALWAYS secure the carrier with the restraint strap.
Toy Caboose Stroller Instruction Manual | Page |