5.Around handlebar center, slide tether strap end through small loop on other end of strap and tighten securely. Photo 1
Photo 1
6.Slide tow bar into trailer receptacles and line up front tow bar hole with rear receptacle hole. Insert retaining pin through both holes and lock retaining hoop securely. Figure 5
7.Test tracking adjustment by pushing trailer. Trailer should roll straight.
To Adjust Tracking
1.Tighten knob to secure stroller wheel in “Stroll” position. See Figure 6
2.Loosen bolt using 5mm hex wrench. Figure 6
3.Turn bushing using 25 mm (or 1”) wrench so that stroller wheel is vertical when viewed from front.
4.Fine tune as necessary, so that trailer rolls straight.
5.Tighten bolt.
Figure 6
4 | B U R L E Y S T R O L L E R K I T O W N E R ’ S I N S T R U C T I O N A N D S A F E T Y M A N U A L |