❃Locking Clip
WARNING
Avoid serious injury or death:
•Failure to use locking clip where required will result in car seat not being securely held in place.
•Remove locking clip from seat belts when not being used with car seat.
You MUST use locking clip provided with car seat with a vehicle seat belt that slides freely through the latch plate or the lap belt cannot be tightly secured.
1Install car seat and tighten vehicle seat belt.
2Hold seat belts together at latch plate (fig. a) then unbuckle.
3Slide locking clip on seat belts approximately 1/2 inch (1 cm) away from latch plate.
4
5Test installation to see if car seat is secure. If not secure, additional belt tightening may be required.
Remove locking clip and repeat steps 1 through 5.
HINT: Tighten vehicle seat belt by pressing base or car seat further down into vehicle seat cushion.
(fig. a)
1/2 inch (1 cm)
19