To USE Jump Seat

Attention Updated Release 04/18/08

WARNING: Please follow all of these instructions to ensure the safety of your child. Keep these instructions for future reference.

To Use Jump Seat you must remove the rear seat.

STEP ONE: REMOVING THE REAR SEAT

1. Unsnap Rear Canopy buttons from the back of the rear seat.

2. Remove the rear canopy by sliding the square fittings upward until they disconnect from the frame.

3. Remove the rear seat from the frame by unbuttoning the upper and lower seat back fabric from the frame (Fig. 13 & 14) and unsnapping both front connection points (Fig. 15).

4. Detach the (2) shoulder straps from the frame by folding and sliding the strap through the “D-Ring” located on the end of each strap (Fig 16).

5. Remove Rear Seat.

ATTENTION: Crotch strap will fit through the bottom of the Rear Seat, do not remove crotch strap.

WARNING!!! Do not use jump seat at this point. The harness strap must be adjusted before proper and safe use can commence. Read below for harness adjustment.

STEP TWO: ADJUSTING SAFETY HARNESS

1. Disconnect straps on jump seat that run underneath the Jump Platform.

2. Remove Jump Seat Pad. Crotch Buckle will fit through provided slots. DO NOT REMOVE crotch Buckle.

3. Pull Crotch Buckle towards the rear of the Sit N Stand so that the buckle will be orientated closer to the edge of the jump platform (Fig. 17).

STEP THREE: INSTALLING JUMP SEAT PAD

1. Feed Crotch Buckle through provided slot closer to the edge of the Jump Pad.

2. Slide the pad over the front of the Jump Seat platform and into the front pocket of the Pad cover.

3. Fold the Pad over the seat and secure the connecting velcro straps together.

Upper

Fig. 13

Snap point

Lower

Fig. 14

Fig. 15

D-ring

Fig. 16

Fig. 17