Installing Tailgate and Splashguard

Nomad:

1.Loop tie-down straps over corners of side panels and join male buckle sections on straps to female buckle sections inside trailer. Figure 3 & Photo 8

2.To accommodate different sizes of cargo, tighten or loosen the webbing straps as needed. Photo 8

Buckle

Webbing Strap

Installing Roll Bar and Cover

Nomad:

1.Place cover over side panels, with “Nomad” logo at trailer front. Figure 3

2.Slip one roll bar knob through a grommet on cover. Figure 3

3.Slide roll bar through casing in divider, and match roll bar end with its corresponding hole on side rail.

4.Thread roll bar knob through side rail, and tighten.

5.Repeat for knob on other side.

6.Loop O-rings on cover over trailer frame tube ends. Make sure cover extends over top of side panels.

Installing Tow Bar

1.Slide tow bar through both tow bar mounts on left side.

2.Match rear tow bar hole with rear mount hole.

3.Insert the retaining pin through both holes, and lock retaining hoop securely. Photo 9 & Photo 10

Trailer

Rear

photo 8

Tailgate

Trailer Frame

figure 3: Nomad

Cover Grommet	Side Rail Roll Bar
Roll Bar Knob

O-Ring

Webbing Strap

Splashguard

	Retaining Pin
Tow Bar Mounts	Trailer Front
Tow Bar Mounts

photo 9: Nomad tow bar installation

B U R L E Y N O M A D A N D F L A T B E D O W N E R ’ S I N S T R U C T I O N A N D S A F E T Y M A N U A L