Getting started
Baby unit battery installation
You can power up the baby unit by connecting it to AC power or to four
AAalkaline batteries. Even if the baby unit is connected to AC power, we recommend you also install four AA alkaline batteries. This guarantees continual operation in case of a power outage.
Install four AA alkaline batteries (not supplied) into the battery compartment, matching the polarity markings (+ and
Make sure the ribbon attached inside the battery compartment is put under the batteries and the excess ribbon is tucked in properly. Then replace the battery compartment cover.
Gently pull the ribbon and lift up to remove the batteries
• Do not mix old and new batteries. Do not mix alkaline and standard
•The operating time for using AA batteries is short, only for a few hours. If you want to monitor your baby for a long time, we recommend you connect your baby unit to AC power.
•If the baby unit will not be used for a long time, disconnect and remove the battery to prevent possible leakage.
•You can use rechargeable AA batteries for the baby unit, but the baby unit cannot charge rechargeable batteries.