Assembly Instructions

With the VTech® Go! Go! Smart Wheels® Spinning Spiral Tower PlaysetTM, safety comes first. To ensure your child’s safety, adult assembly is required.

Assemble the spiral tower:

1.Locate the tower base that is labeled with a number “1” engraving on the bottom. Insert three tower support pieces as shown.

2.Place the spiral ramp piece with the number “2” engraving on the bottom over the center pole on the tower base. Then adjust the spiral ramp piece so the slots on the bottom fit snugly onto the two support pieces as shown.

3.Attach the spiral ramp piece with the number “3” engraving on the bottom in the same way. Adjust it so the spiral fits snugly over the remaining support piece.

4.Insert the final two support pieces into the slots of the spiral ramp with the number “2” engraving.

Assembly Instructions