Radio Shack 60-479 warranty Transmitter, Before Flying, Charging the Microfighters

PLEASE! DO NOT RETURN THIS PRODUCT TO ANY RETAIL STORE!

For any questions or problems with this product please contact us at:

Web site: www.interactivetoy.com

Email: info@interactivetoy.com

Phone: Outside North America: +1 416 444 6873

Inside North America: 1 866 214 2220

Address: Interactive Toy Concepts

12

Thank you for purchasing the MicroFighters, the world’s smallest and most progressive digital proportional radio control aircraft. To insure safe and reliable operation, please read the entire contents of this manual before removing the aircraft from its package.

1192 Martin Grove Road

Toronto, Ontario, Canada

M9W 5M9

IMPORTANT SAFETY INFORMATION

Do not modify your MicroFighters! Do not point the antenna directly at the plane! Do not use in strong winds, use only in VERY mild conditions! Do not use in rain, snow or around heavy debris! Do not use near electrical lines! Do not use around smoke or flames! Do not use around water! Do not use around electricity! Do not use in crowded areas! Do not use around air conditioning! Do not use around air vents! Do not use around ceiling fans! Do not use around large obstacles! Do not use in very small spaces! Do be conscious of changes in your area! Any changes or modifications to this product are strictly prohibited and will void product warranty. Keep moving propellers away from eyes, hands, hair and loose clothing. Always turn off your MicroFighters and transmitter when not in use. Always remove batteries from transmitter during storage. Always place transmitter with NEW alkaline batteries for optimal performance. Keep your Pilot’s manual in a safe place for future use. Only use the provided charger included with the MicroFighters to charge the lithium polymer battery installed in the MicroFighters.

IMPORTANT BATTERY INFORMATION

Use only batteries recommended in this instruction manual. Do not mix old and new batteries.

Battery installation should be performed by an adult. Be careful to install the batteries with the correct polarity, as indicated.

Do not use rechargeable batteries. Do not mix alkaline, standard, lithium, rechargeable, or different types of batteries. The supply terminals are not to be short-circuited. Exhausted batteries are to be removed as they will hinder performance. Never leave a battery unattended while it is being charged. Never leave a battery unattended in the presence of children. MicroFighters charging time will increase with usage as the condition of the AA cells diminish. Battery performance may greatly influence flight characteristics. MicroFighters Li-Po rechargeable battery is not replaceable.

Please Note:

MicroFighters is an advanced aircraft that uses sophisticated onboard technology

unlike any found in similar aircrafts. Even

experienced pilots should read the full contents

of this manual carefully to receive the most from your flying experience.

Parts Index

MICROFIGHTERS	4	5
1.Propeller
2.Horizontal tail
3. Wing		3
4.Charge port
5.ON/OFF Switch
To prevent damage during
shipping, your MicroFighters
is securely fastened in the
package. Please insure that
all tie downs and fastening		1
locations have been unfastened
before attempting to remove the		2
aircraft from its package.

			•MicroFighters		1PC
			•Transmitter		1PC
			•Antenna		1PC
			•Instruction manual		1PC
	Do not touch the running propeller!		•Landing gear		1PC
			•Spare Propeller		2PCS
	Adult supervision is required!
	TRANSMITTER		6	4	7
1.	Throttle control	1	6		2
2.	Steering control
3.	Charging lead compartment
4. Antenna
5.	Steering Trim knob				5
6.	Power LED “Red”

7.Charging LED “Green” 8

8.ON/OFF switch

3

MicroFighters takes 6 AA battery (not included).

FCC NOTE: U.S. ONLY

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1) This device may not cause harmful interference. 2) This device must accept any interference received including interference that may cause undesired operation. Warning: Changes or modifications to this unit not expressly approved by the party responsible

for compliance could void the user's authority to operate the equipment. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These Limits are designed to provide reasonable protection against harmful interference in a residential installation. This generates, uses and can radiate radio frequency energy and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try and correct the interference by one or more of the following measures: - Reorient or relocate the receiving antenna - Increase the separation between the equipment and receiver - Connect the equipment to an outlet on a circuit different from that to which the receiver is connected - Consult the dealer or an experienced radio/TV technician for help.

Industry Canada Notice: Canada only.

This radiocommunication device complies with all the requirements of Industry Canada Standard RSS-310. Operation is subject to the following two conditions: 1) This device may not cause harmful interference.

2) This device must accept any interference received, including interference that may cause undesired operation.

Field Strength and measurement distance: 27.145MHz – 54.95 dB—V/m at 3 meters. 49.860MHz - 63.86 dB—V/m at 3 meters.

Limited 30-day warranty

This product is warranted by Interactive Toy Ltd. against manufacturing defects in material and workmanship under normal use for thirty (30) days from the date of purchase. Please retain proof of purchase.

Lithium Polymer	AirRage Series and MicroFighters are registered
	trademarks of Interactive Toy Concepts © 2009
Rechargeable Batteries	All rights reserved. Manufactured by and distributed
must be recycled or	by Interactive Toy Concepts Ltd.
disposed of properly.	Products and colors may vary.
	MADE IN CHINA.

IM-44005-90131-US

BEFORE FLYING

1.Use a Phillips head screw driver (cross head) to loosen screw and remove cover .

2.Insert 6AA batteries in the correct polarity as indicated inside the battery door cover.

3.Place cover back and re-tighten screw .

4.Screw antenna in place.

CHARGING THE MICROFIGHTERS

1.Make sure the power switch of the MicroFighters is

in the OFF position. NOTE: Always switch OFF the plane after flying!

2.Make sure the controller antenna is collapsed to avoid breaking it while not flying and to prevent accidentally interfering with another RC aircraft on the same frequency.

3.Remove the charge lead on the transmitter and insert it into the charge port on the MicroFighters.

NOTE: Always insure you insert the charge lead using the correct orientation.

4.Turn the transmitter switch to the ON position.

5.Green LED will blink indicating plane is now being charged.

6.Charge the MicroFighters fully which typically takes about 30 min.

7.Green LED will stop blinking and light steadily, indicating that the plane is fully charged.

8.Remove lead and place back inside storage compartment.

9.Turn transmitter OFF.

10.If you forget to turn off the transmitter and are not moving the control sticks, after 3 minutes the red LED will start blinking to remind you to turn it off!

NOTE: The MicroFighters will enter sleep mode if idle over 3 minutes. To "wake up", power off both your Microfighters and the transmitter, and then turn on again. If battery is low the green LED will blink.

TIP: Unlike other types of rechargeable batteries, Lithium Polymer rechargeable batteries do not require a full charge for operation. However it is necessary to FULLY charge on the first flights for best results. *Shorter Charges = Shorter Flight Times. Precaution: This product is design to operate in altitude below 4000ft! If the operation geographic environment is over the designed altitude, the flight time may shorten and the product may not function correctly.