Assembly

UNIT SHOULD ONLY BE ASSEMBLED BY AN ADULT.

1.Charge your boat’s battery by connecting the Ni-MH rechargeable battery (6) to A/C Adaptor (5) and plug into a 110 volt wall outlet.

2.Allow battery to charge for a full 8 hours before first use.

3.Remove red cap by twisting a ¼ turn. Insert 9-volt Battery (4) into Remote Control (2). Replace red cap by twisting a ¼ turn.

4.Carefully screw the telescoping antenna into hole on the top of the remote control.

5.Feed antenna wire on boat through Clear Plastic Sleeve (7) and loosely knot at the end. Clear Plastic Sleeve (7) with antenna wire must be in the upright position to work properly.

6.Once fully charged, unclip battery (6) from A/C Adaptor (5) and clip to the battery clip located under the back seat of the boat. Insert rechargeable battery (6), replace cover and secure.

7.Turn remote control on at the switch. Turn the boat on with the button located on the bow and extend the remote’s antenna.

8.Test the boat with the propeller’s pointed away from you, and other people, before placing in water.

9.Inside the accessory packet you will find 2 pre-assembled fishing lines (3). Clip end of line to eyelet located at the rear of the boat.

10.Always have adult supervision while baiting your hook. Once hook is baited, lower your boat into the water using the Retrieving Hook

(8) and steer your boat towards the fish.