Algolith VLD-1002-MD operation manual Power Consumption, Front Module

Page 8

 

VLD-1002-MD

Guide to installation and operation

 

 

 

Power Consumption

The power rating of the openGear frame allows 125 watts to be redistributed over 10 slots. A single slot may exceed 12 watts but the overall power consumption shall not be above 125 watts.

The VLD-1002-MD dissipates 14 watts.

An openGear frame, when populated with Algogear cards only shall use no more than 8 slots.

Blank slot fillers can be used to block slots in an openGear frame. A warning message is affixed to the VLD-1002-MD card and other Algogear cards to ensure the user is aware of the card’s power consumption when installing new systems, or rearranging frame configurations.

openGear frame Blocked frame slot Algogear cards

ALGOGEAR

ALGOGEAR

DO NOT REMOVE

ALGOGEAR

Front Module

The VLD-1002-MD card is identified with a product label located near the card’s front edge. When installed in a frame and powered, the card displays the product name on a dot matrix display. See drawing below.

Card status (DS1)

Input 1 status (DS2) Input 2 status (DS3)

Not used on VLD-1002-MD (DS4) Not used on VLD-1002-MD (DS5)

Card reference status (DS6)

ALGOGEAR

VLD-1002-MD

VLD1 002M

Dot matrix display

Product label

8

Page 7 Page 9
Image 8
Page 7 Page 9
Contents Dual SD/HD Video Delay Table of Contents Safety Introduction Installation and setupHow to Repurpose your Card Specifi cations Limited Warranty Contact usRestrictions on Hazardous Substances Electromagnetic CompatibilityMain Features OverviewAlgogear Series Card IdentificationBoard Installation Static DischargeVLD-1002-MD card is installed in the openGear frame Power Consumption Front ModuleRear Input / Output Module Labels VLD-1002-MDOutput Channels Dashboard Software Interface Basic Tree View Window Product Status AreaCard Info Window Card Status WindowControl Card Setup, Video Setup and Alarm Setup windowsCard License Window Adjusting Parameters Administrator LevelAdmin Login Admin LogoutChannel Settings Card Setup WindowSave Settings Destination Selecting the Reference Reference SelectionOpenGear Frame VLD-1002-MD rear module Video Format Video Setup WindowVideo Default Mode Video Delay frame Video DelayVideo Delay sec Maximum Delay in Seconds & Frames Video Delay ApplyAlarm Setup Window How to Repurpose your Algogear Card Load the new product onto your card Click Upload to get to the .BIN file Card is in the process of being repurposed Dot matrix display VLD-1002-MD Specifi cations SD/HD SDI VideoLimited Warranty Coverage Algolith IncVia Internet Visit us at
Top Page Image Contents