Battery Replacement
+ | 1.5V x 3 | - |
| "C" (LR14) |
|
For best performance, we recommend replacing the batteries that came with this toy with three, new “C” (LR14) alkaline batteries.
•Locate the battery compartment on the bottom of the toy.
•Loosen the screws in the battery compartment door with a Phillips screwdriver. Remove the battery compartment door.
•Remove the exhausted batteries and throw them away.
•Insert three, new “C” (LR14) alkaline batteries.
Hint: We recommend alkaline batteries for longer battery life.
•Replace the battery compartment door and tighten the screws.
•If this product begins to operate erratically, you may need to reset the electronics. Slide the power/volume switch off and then back on.
•When sounds or lights from this toy become faint or stop, it’s time for an adult to change the batteries.
• Protect the environment by not disposing of this product with household waste (2002/96/EC). Check your local authority for recycling advice and facilities (Europe only).
Battery Safety Information
In exceptional circumstances, batteries may leak fluids that can cause a chemical burn injury or ruin your product. To avoid battery leakage:
•Do not mix old and new batteries or batteries of different types: alkaline, standard
•Insert batteries as indicated inside the battery compartment.
•Remove batteries during long periods of
•Never
•Use only batteries of the same or equivalent type, as recommended.
•Do not charge
•Remove rechargeable batteries from the product before charging.
•If removable, rechargeable batteries are used, they are only to be charged under adult supervision.
FCC Statement
(United States Only)
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and,
if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
•Reorient or relocate the receiving antenna.
•Increase the separation between the equipment and receiver.
•Consult the dealer or an experienced radio/TV technician for help. Note: Changes or modifications not expressly approved by the manufacturer responsible for compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference and (2) this device must accept any interference received, including interference that may cause undesired operation.
ICES-003
•This Class B digital apparatus complies with Canadian
•Operation is subject to the following two conditions: (1) this device may not cause harmful interference and (2) this device must accept any interference received, including interference that may cause undesired operation.
NMB-003
•Cet appareil numérique de la classe B est conforme à la norme
•L’utilisation de ce dispositif est autorisée seulement aux conditions suivantes : (1) il ne doit pas produire de brouillage et (2) l’utilisateur du dispositif doit être prêt à accepter tout brouillage radioélectrique reçu, même si ce brouillage est susceptible de compromettre le fonctionnement du dispositif.
3