Fisher-Price V7310 instruction sheet Elevator Walls Elevator Floor, Elevator Roof, Pegs

Page 8

Assembly

Elevator Walls

Elevator Floor

10

• Fit two elevator walls into the slots in an elevator fl oor.

Hint: The elevator walls are designed to fit into the elevator floor one way. If they do not seem to fit, turn them over and try again!

• Push to “snap” each in place.

Elevator Roof

11

Fit an elevator roof onto the elevator walls. Push near each of the four corners to “snap” in place.

Hint: The elevator roof is designed to fit onto the walls one way. If it does not seem to fit, turn it around and try again!

Repeat this procedure to assemble the other elevator.

Pegs

12

Elevator

Fit the center pegs on the elevator crane into the grooves in an elevator. Push to “snap” the elevator in place.

Hint: The elevator is designed to fit on the elevator crane one way. If it does not seem to fit, turn it around and try again!

8

Image 8
Contents V7310 Tower Top Elevator Floors Elevator Walls Ramp Elevator CraneBoulder Crane Boulder Hopper BaseBattery Safety Information Consumer Assistance FCC Statement United States OnlyGray Supports AssemblySupport Wall Track Yellow Support Gas Pump Tower TopBoulder Crane Pegs Elevator Walls Elevator FloorElevator Roof Assembly Battery Installation TruckRemote Control Power Button Ready Light Color Control SteeringBig Action Big Action Troubleshooting To the remote controlTruck drives slowly Truck does not respondStorage Care