Assembly
Elevator
Base
1
•Insert the tabs on the bottom of the elevator into the slots in the base.
•Push to "snap" in place.
Pump
2
•Insert the tabs on the pump into the slots in the base.
•Push to "snap" in place
Post
3
•"Snap" the tabs on the post onto the base.
Columns
4
•Set the assembly on its side, and locate the tabs on the base.
•Fit a column onto one of the tabs. While holding the column in place, insert a screw into the hole in the tab and tighten.
•Repeat this procedure to attach the other column.
•Set the assembly upright.
3