Assembly
Walls
1
• Fit the upper and lower walls together, as shown. | 3 | Bases |
|
| |
|
|
|
• Place the bases on a flat surface, as shown.
• Fit the wall assembly into each base and push to “snap” in place. Hint: The wall is designed to fit the bases one way. If it does not seem to fit, turn or switch one or both bases around and try again!
Blue Dots
2 | 4 Screws |
|
• Insert four screws into the holes in the wall assembly and tighten.
Top View
Ramp
Labeled 2
4
•Locate the ramp labeled with a 2.
•Fit the ends of the ramp into the slots in the wall, as shown.
Hint: The tab at the top of the ramp has a blue dot on it. Match
5this dot to the slot with the blue dot.