ASSEMBLY
5
•Tighten the screws with a Phillips screwdriver. Do not
•Repeat this procedure to attach the other ends of the frame tubes to the frame on the other side of the base.
Frame
6
Lower Hole
Spring
Lower Hole
Base Wire
Spring - 4 |
|
M6 x 15/8" Screw - 4 | Protruding Side |
M6 Lock Nut - 4 |
7Metal Canopy Stay
Cover
Upper
Hole
Slot | Tab |
| Protruding |
| Side |
M5 x 113/16" Screw | M5 Lock Nut |
•Position one end of the metal canopy stay against the upper hole in a frame.
•Insert an M5 x 113/16" screw through the hole in the cover.
•Fit the end of the screw through the hole in the metal canopy stay and into the upper hole in the frame.
•Push on the cover to insert and “snap” the tab on the cover into the slot in the frame. Make sure you hear a “snap”.
•Fit an M5 lock nut (so that the protruding side is toward the fabric) into the upper hexagonal opening on the back of the frame.
•Tighten the screw with a Phillips screwdriver. Do not
•Repeat this procedure to attach the other end of the metal canopy stay and the remaining cover to the frame on the other side of the base.
•Position the base wires around the base so that the ends point upward and are against the lower holes in a frame.
•Place a spring onto an M6 x 15/8” screw.
•Insert the M6 x 15/8" screw with spring through a base wire and into the frame.
•Fit an M6 lock nut (so that the protruding side is toward the fabric) into each lower hexagonal opening on the back of the frame.
•Tighten the screws with a Phillips screwdriver. Do not
•Repeat this procedure to attach the other ends of the base
wires to the frame on the other side of the base. | 5 |
|