Go-Go Babyz NMJ2 manual How to properly Assemble your gogo Kidz Travelmate

How to properly

Assemble your gogo Kidz™ Travelmate

For the Roundabout®, Marathon™ & Decathlon™

Step 1. Lay seat face down and insert retainer bar in between seat-belt holder of car seat.

Step 2. Align the bottom tabs with the bottom of the car seat and lay the gogo Kidz plate on the back of the car seat.

Step 3. Insert the screws into the holes on the back of the plate and tighten. You may need to pull up on the bar while screwing.

Special Instructions for Inserting the Retainer Bar with the Wizard® or Boulevard™ car seat

Please follow the instructions above for complete assembly.

To attach the Wizard/Boulevard Retainer Bar, roll the cut out portion around the bar in the back of the seat, starting from the bottom with the cut out prtion facing the top of the seat. The two conical sections should be facing towards you at this point. Use the fingers of one hand to align the conical shapes with the holes int he main plate and thred the Thumb- screws with the other hand.

Special Instructions for transporting your child in the gogo Kidz™ Travelmate

The gogo Kidz needs no special instructions when transporting the Britax® seat from place to place. However, when transporting a child over 35 lbs., strapped in the seat, follow these instructions:

Step 1. Attach the gogo Kidz to the Britax car seat by following the assembly instructions. After the gogo Kidz is attached to the Britax seat, and the handle is in the collapsed position, pull 10 inches of the “versa-tether” strap from the pouch that is located on the rear of the seat near the top.

Tether Pouch

Step 2. Pull the strap over the handle and tighten the “versa-tether” by pulling on the end of the tether strap. Place excess strap back into the pouch. Tuck in all remaining latch and tether straps in order not to get tangled when in use.

Step 3. Always secure your child with the safety harness provided by the car seat manufacturer.