Kyocera 4230 When Paper Misfeeds, 174, Misfeed location indicators, Do not reuse misfed paper

WHEN PAPER MISFEEDS

If a paper misfeed occurs, copying will stop. A misfeed message will appear on the touch panel as well as misfeed locations are indicated. Remove the misfed paper referring to page 177, “(3) Remove procedures” with the main switch ON ( ❘ ).

(1) Misfeed location indicators

1Misfeed in paper feed section (page 177)

2 Misfeed in paper transfer section (page 181)

3 Misfeed in fixing unit/ejection section (page 183)

4 Misfeed in duplex unit (page 185)

5 Misfeed in DF (page 187)

6 Misfeed in finisher (optional) (page 189)

(2) Cautions

WARNING

High voltage is present in the charger section. Take sufficient care when working in this area, as there is a danger of electrical shock.

CAUTION

The copier's fixing unit is extremely hot. Take sufficient care when working in this area, as there is a danger of getting burned.

●Touch the “?” key to display the misfed paper removal procedure on the touch panel.

*Do not reuse misfed paper.

*If paper gets torn during removal, be sure to remove any loose scraps from inside the copier, or they could cause further misfeeds later.

*After removal of misfed paper, warm-up will begin, the misfeed message will disappear, and the copier will return to the same settings as before the misfeed.

*Even if a misfeed occurs in the finisher, do not reset the misfed copy into the tray, as it will be automatically copied again.

174