MESSAGES

When the messages below are displayed:

When any of the messages below appear on the touch panel, take the action indicated.

Message

Action

Page

 

 

 

“Close xxx cover.”

The cover displayed is open. Close it/them securely.

__

 

 

 

“Add paper in drawer.”

There is no paper in the drawer displayed. Load paper of size indicated.

31

 

 

 

“Set drawer.”

One of the drawers is not closed properly. Pull it out, and push it back in

33

“Set the paper drawer.”

all the way.

 

 

 

 

“Push Fixing unit until it stops”

The fixing unit is not set securely. Open the front cover and the left cover

185

and push the fixing unit securely into its original position.

 

 

 

 

 

“Drawer inoperable.

The drawer currently in use is out of order and cannot be used for the

__

moment. Contact your service representative as soon as possible.

Call for service.”

Continue copying using another drawer.

 

 

 

 

 

 

“Check paper size.”

There is no paper of the appropriate size for the mode which has been

__

 

set. Check the paper.

 

 

 

 

“Reposition original or

The orientations of the original(s) and the paper selected are different.

 

Change the orientation of the original(s). If the Start key is pressed without

38

change drawer.”

changing the orientation of the original(s), same-size copying will be

 

 

performed.

 

 

 

 

“Reset all originals in feeder.”

Original(s) has not been fed correctly during feeding into the DF. Remove

38

all originals and set them again.

 

 

 

 

 

“Reset all originals in feeder.”

An original is misfed inside of the DF. Remove the misfed original

187

following the procedure, remaining the main switch ON ( ).

 

 

 

 

 

“Cannot duplex copy on this size.”

Two-sided copying cannot be performed on small size paper like 51/2" x

53

81/2" or custom size. Change the paper size.

 

 

 

 

 

“Install duplex unit.”

Duplex unit has not been set correctly. Set it securely.

__

 

 

 

“Duplex tray inoperable,

Problem in the duplex unit. 2-sided copying is not possible. Contact your

__

call for service.”

service representative as soon as possible.

 

 

 

 

“Ready to copy.

There is not enough toner in the copier. Replace the toner cartridge

172

Add toner to resume copying.”

immediately as only one copy at a time can be made.

 

 

 

 

“Add toner to resume copying.”

There is not enough toner in the copier to make copies. Replace the toner

172

cartridge immediately.

 

 

 

 

 

“Call for service.”

Open and close the front cover. If this message does not disappear, make

__

a note of the “C” and numbers appearing with it, turn the main switch OFF

 

(O), and contact your service representative.

 

 

 

 

166

Page 171
Image 171
Kyocera 4230, 5230 manual Messages, 185, 187, 172, 166