Fisher-Price EF20B Check Harness Height, Harness Height Adjustment, Weight Range, Maximum Height

Page 7

Using the Restraint

Check Harness Height

1.Place child in restraint, then secure harness (see Secure Your Child in the Restraint, pages 8 and 9).

2.Observe where the harness is positioned on the child. Rear-facing harness straps should be located in the nearest slot at or below the child’s shoulder. Forward-facing harness straps must be located at or above the child’s shoulder (Fig. 1).

3.If harness height is correct, continue using child restraint without adjustment. If harness height requires adjustment, refer to Harness Height Adjustment on page 13.

Using the Restraint

Harness Height Adjustment

1. To loosen the harness, lift the harness adjuster lever and pull the harness straps forward . (Fig. 1).

1

Rear-Facing

Forward-Facing

1

Weight Range

Rear-Facing

5–33 lbs. (2.3–15 kg)

Forward-Facing

20–55 pounds (9–25 kg)

Maximum Height

Rear-Facing

The child is too tall when the top of the head is 1 inch from the top of the restraint.

Forward-Facing

The child is too tall when the tops of ears are above the top of the restraint or height exceeds 49 inches (124 cm).

2. At the back of the restraint, unhook the harness straps from the yoke (Fig. 2).

3. Pull straps through the shell and cover.

2

4. Thread the harness straps through slots in shell at the new height (Fig. 3).

5. Reattach harness straps to the yoke (Fig. 2).

6. Pull harness adjuster strap to tighten the harness.

IMPORTANT!Verify that both straps are threaded at the same height and are not

twisted.3

12

13

Image 7
Contents Safe Voyage Deluxe Convertible Car Seat Features Safety InformationTypeIMPORTANT Notes SafetyFeatuInformationesFeatures FeaturesSecure Your Child in the Restraint Using the RestraintUpright Position Reclined PositionMaximum Height Harness Height AdjustmentWeight Range Check Harness HeightVehicle Seating Positions Vehicle Safety BeltsLatch Installation Rear-Facing InstallationLatch Removal Locking Lap-Shoulder Belt Installation Facing mode. See IMPORTANT! When installing the restraint with Lap Belt InstallationTypeLATCH Installation Forward-FacingeaturesInstallationAlways use in upright position TypeLocking Lap-Shoulder Belt InstallationForward-Facing Installation Check Buckle Position Installation in AircraftRear-Facing Installation Forward-Facing InstallationBefore installing restraint Using the TetherCare andFeaturesMaintenance CleaningType the Buckle BuckleType Removal and ReplacementLimited ONE-YEAR Warranty WarrantyFeatures