Combi 8600 Series instruction manual Seat Back Assembly, Additional Information

Page 8

13

Section 9 - Seat Back Assembly

Installing and Removing Seat Back:

To install seat back:

Place Booster Car Seat base on floor or firm surface.

Holding seat back slightly reclined, place tabs at bottom of seat back into slots of seat base 1 (fig. a).

Rotate seat back upright 2 .

Press down firmly until wings on side of seat back touch arms on seat base 3 .

To remove seat back:

Place High Back Booster Car Seat on the floor or other firm surface.

While holding the base down, pull the seat back straight up until it stops, then rotate seat back into a reclined position and lift out.

 

2

 

 

 

3

 

 

Base

Seat

 

 

Back

 

 

 

1

 

Wings

(fig. a)

Top Of

 

 

Arms

Section 10 - Additional Information

Certification

This child restraint system conforms to all applicable Federal Motor Vehicle Safety Standards for use in motor vehicles.

Aircraft Use

This restraint (Booster Car Seat) is NOT certified for aircraft use (see label on car seat). An aircraft does not have lap and shoulder belt systems required to use with Booster Car Seats.

Warm Weather

Car seat parts can get very hot in the sun or warm weather.

To avoid burns, always check before putting child in car seat.

Vehicle Seat Protection

Protect vehicle seat. Use a thin car seat mat, thin towel, or thin blanket under and behind car seat.

Instruction Manual Storage

Store instruction manual under seat pad.

Car Seat Useful Life

DO NOT use after 7 years from date of manufacture on label.

14

Image 8
Contents Yorktown Booster Car Seat Proper Use Is Required Table of Contents Proper Use Check ListYorktown Booster Car Seat Parts Use RecommendationsSelecting a Vehicle Seating Location Vehicle Seat Belt SystemsHigh Back Booster Car Seat Use Securing Child With Lap And Shoulder BeltBooster Car Seat Use Without Seat Back Fig. fSeat Back Assembly Additional InformationCare and Cleaning Registration Information