Section 7 - Installation and Use
7.2-Auto Belt - Base Installation with Lap Belt
1- After Ball is in the green area on Level indicator, open Lock Off and thread auto safety belt through the labeled “Belt Here” auto safety belt path.
2- Press down on base with knee, tighten auto belt and insert buckle tongue into buckle.
Close and secure “Lock Off” to eliminate slippage. Pull on auto safety belt to ensure the auto buckle is secure.
3- CHECK level indicator to ensure the ball is in the green area. Pull out on
the yellow release knob and slide the angle foot to raise the base or to lower the base angle.
4- CHECK base at safety belt path for movement. Base should not move more than 1 inch in any direction.
5- If base moves, repeat steps until all safety steps are met.
17
Lap |
|
|