The First Years I440 manual Check That Handle is Locked

Page 25

Section 7 - Installation and Use

Handle - 7.7

1. Positioning of Handle

-Press red button on both sides of the handle to move handle.

-Only use position A to carry the Infant Seat.

	B	A
C	B
D
E

2- Check That Handle is Locked

- Before the Infant seat is lifted for any reason, check to make sure handle is locked into position by pushing forward and pulling back on the handle.

3- Handle position in auto

- Never have handle in position A when infant seat is installed in the automobile. Position B, C, D or E are acceptable use positions in the automobile.

WARNING

•Prevent injury. Never have handle in position A when the Infant Seat is installed in the automobile.

24

Image 25

Contents Death or Serious Injury can occur Introduction Table Of Contents Table Of Contents Death or Serious Injury can occur Death or Serious Injury can occur Use Recommendations Infant Seat Parts Infant Seat Parts Position equipped Selecting a Vehicle Seating LocationFirst Years Policy Statement Selecting a Vehicle Seating Location YES Lap belt with automatic locking retractorALR Unsafe Vehicle Seat Belt Systems Death or Serious Injury can occur Leveling base Base InstallationAuto Belt Base Installation with Lap Belt Installation and Use  Anchor points CRS Connector Latch Anchor PointsCRS Locking Clip Installation Installing Carrier onto the Base This carrier must always be used with the base CRS Installation PictogramsInfant Seat and Base installed with Lap belt Check That Handle is Locked HandleGrip red handle and gently pull up I440 Removal from baseHarness System Chest ClipPoint Buckle Harness. System Harness AdjusterShoulder Height Adjustment Canopy Installation and UsePositioning/Removal The Head Bolster is held in place Head BolsterPad Removal Pad Installation Safety Checklist/Safe Practices Safety Checklist/Safe Practices Additional Information Care and Cleaning Blank Learning Curve Brands 4000000609 02