FOLDING and STORING
Playard/Crib
1To remove floorboard:
• Unfasten attachment straps.
• Remove floorboard and set aside.
2 To unlock and raise floor:
• Push down on center of Playard/Crib floor.
• Lift Floor Handle and rotate in direction of arrow (counterclockwise).
• Pull up on Floor Handle to raise floor.
Raise approximately 45.7 cm
(18 inches).
4 Gather Playard/Crib frame together | Floor Loop |
while pulling up on Floor Loop. |
|
5 Wrap floorboard around Playard/Crib frame with padding facing in.
Handle
6 Secure Attachment Straps:
Floor 
Handle
3 To fold top rails:
• Pull up on top rail slightly.
• Squeeze Release Button on bottom of top rail and push rail down. (Release buttons are identified by printed arrows.)
Repeat for other sides.
• Bottom - Thread Attachment Strap through Leg Loop then through Floorboard Loop and fold back onto itself.
• Middle and Top - Thread
Attachment Straps
through remaining floorboard loops and fold back onto themselves.
Attachment
Straps
NOTE:
•If rails are difficult to unlock, raise center of floor higher and squeeze Release Button again.
•If only one side of rail folds, squeeze Release Button again to fully fold.
Release 
Button
Floorboard Loop | Leg Loop |
|
7 Stand Playard/Crib on end and pull travel bag over Playard/Crib.
Be sure Handle comes through Opening in bag.
Turn over Playard/Crib and | Opening |
zip bag closed. | Handle |
|
8