Step 3.
Repeat above steps for the other side.
Pull firmly on each wheel assembly to be sure the wheel assemblies are securely attached.
To Assemble Rear Axle
Step 1.
Before assembling rear axle, it is necessary to recline the front seat to protect it while the stroller is inverted. To recline the front seat, push back of seat slightly forward while pulling up on wire as shown to unlock. Recline seat back.
Step 2.
Turn stroller over.
Step 3.
To prevent serious injury or death from choking, remove and immediately discard the plastic covers on the axle.
Position rear axle assembly as shown, with brake levers pointing toward rear of stroller.
Step 4.
Push both brackets on until plastic tabs snap into the holes on the leg tubes.
Pull firmly on each bracket to be sure the brackets are securely attached.
To Assemble Rear Wheels
Place one rear wheel, red retainer and white cap on one end of rear axle in order as shown below. Push red retainer onto axle BEFORE attaching white cap. Repeat on other side.
Wheel |
|
Spokes toward | Cap (white) |
Attach AFTER | |
inside | retainer is on axle |
Rear axle | Retainer (red) |
| Wide end |
| toward wheel |
Snap red retainer
into axle groove. Then snap cap over red retainer as shown.
To Attach Front Tray and Rear Arm Bar (arm bar on certain models only)
Always secure your child with the seat belt. The tray and arm bar are not restraint devices.
DO NOT lift the stroller by the tray or arm bar.
Use care when clamping the tray or arm bar on the stroller with a child in the stroller.
Ensure plastic tray supports are positioned as low on front legs as possible. Snap the tray
onto front legs of stroller as shown. Snap the arm bar onto the rear armrests. Push down
on tray and arm bar to be sure
they are securely clamped onto
the stroller.
Tray 
support 
Tab
To remove, first pull tab on one side out and toward you, then unsnap the other side of the tray or arm bar.
Tab
7 | 8 |