CONTROLS: (Continued)
SOLO: (Continued)
SOLO, a pre-settable boost in overall levels is possible on the fly...giving you some control over your levels when it’s time to step out. Engineers may give you a bit of a frown the first time you use it...but isn’t it time you heard yourself. It might even prevent them from punishing you with the dreaded monitor or sidefill version of your tone.
STANDBY:
Perfect for set breaks... this toggle switch also serves an even more important purpose. In the Standby position the tubes are at idle so that during power up they may warm up before being put to use. Before Power is switched on make sure the STANDBY switch is in the Standby position. Wait at least 30 seconds and then flip the STANDBY switch to the ON
position. This prevents tube problems and increases their toneful life substantially.
ONON
POWER STANDBY
HEAD VERSION
POWER:
This switch delivers the A.C. power to the RECT-O 50. Make sure the unit is grounded (all three terminals of the A.C. power cord must be connected whenever possible to avoid injury to the user as well as to the unit) and that the proper voltage is present. Follow the cold start procedure described in the ON/ STANDBY section above when powering up your
new RECT-O 50.
ON ON
POWER STANDBY
HEAD VERSION
REST AREA