Graco ISPC008BA 08/02 manual REAR-FACINGINSTALLATION with Latch

Page 10

REAR-FACINGINSTALLATION WITH LATCH

1LATCH belt must be routed through opening in car seat for rear-facingmode. (see page 23, fig. j).

Belt must lay flat and not be twisted.

2Adjust car seat to recline position

(see pages 18 and 19, fig. b) and place rear-facingon vehicle seat equipped with LATCH anchors.

3For ease of installation, extend LATCH belt to its maximum length.

4Hook connectors to vehicle lower anchors (fig. a). Pull connectors to be sure they are securely attached to the anchor points. (fig. b).

5Press down firmly in center of car seat while pulling LATCH adjustment belt. (fig. c).

6

7

Pull front to back and left to right to check for secure installation (fig. d).

Check that the lower anchorage belt stays tight and does not slip from the tightened position. If it does not stay tight, try another seating position or contact Customer Service (see back cover).

Check level indicator on car seat.

Vehicle must be on level ground

and child in car seat when checking level indicator.

Ball MUST be entirely in green zone (fig. e). If necessary, place rolled towels under car seat, at vehicle seat crease, until entire ball is in green zone. Then re-check level indicator.

DO NOT use tether rear-facing. Tether must be stored (see “Tether Storage” page 32).

Periodically check that car seat is securely installed and properly leveled; adjust if necessary.

8

Image 10

Contents Avoid injury or death Table of Contents Important Information Safety First Check ListRegistration Information Do not use rear-facing child Replaced. do not use it again! a Vehicle Seat Protection Basic InformationCertification Unoccupied Car Seat Warm WeatherWhat is LATCH? Latch System Vehicle Top Tether Anchor Point Car Seat Lower PointsOutgrowing Car Seat Height & Weight LimitsPreterm or Low Birth Weight Infants Rear-facing 5 to 30 lbs .6 kgREAR-FACINGINSTALLATION with Latch Fig. e Fig. dFORWARD-FACING Installation with Latch FORWARD-FACING Installation with Latch Tether Openings Pull to tightenREAR-FACING Installation with Vehicle Seat Belts Storage Bar Openings Towels Tether FORWARD-FACING Installation with Vehicle Seat Belts Openings Pull to Tighten StandPoint Models Only Placing Child in CAR SeatCheck harness system Overhead Shield Models OnlyPlacing Child in CAR Seat Harness Straps fig. a Point Crotch Strap Adjustment fig. cOverhead Shield Adjustment fig. d Harness TiePull Belt Clip Upright LiftRecline For Toddlers Changing Harness Strap SlotsPoint Models fig. e For Infants or Small Toddlers Overhead Shield Models fig. fSplitter LoopPlate Belt Latch Belt RoutingLatch belt. fig Under seat padRear-facing Forward-facingRemoving Latch from Vehicle Anchor Points Fig. lLatch storage Fig. p or qVehicle Seat Belts Vehicle Seat Belts Belts Forward of Seat CreaseLap Belts With Retractor Lap Belts Manually AdjustableFlip Passive Restraint Lap Belt with Motorized Shoulder Belt Passive Restraint Lap or Shoulder Belt Mounted on DoorCombination Lap/Shoulder Belt with Locking Latch Plate Combination Lap/Shoulder Belt with Sliding Latch PlatePull Locking Clip For storage of tether hook Additional InformationTether Storage Tether Hook Back of Car SeatRemoving Cup Holder Cup HolderAvailable on some models TabRemoving Seat Pad Care & CleaningRemoving Overhead Shield Pad Harness Straps and Latch belt Aircraft UseSeat Pad and Overhead Shield Pad Shell and Overhead Shield Cup HolderParts List How to OrderShip to Both Numbers RequiredCall US First Manual de instrucciones Utilización Tabla DE ContenidoInformación especial Información de registro Información ImportanteLista de control de seguridad Advertencia Prevenga lesiones graves o la muerte Orientación trasera debe nivelarse Advertencia Información BásicaSistema Latch para vehículos ¿QUÉ ES EL LATCH?Anclaje Sistema Latch El sistema LatchLímites DE Altura Y Peso De 20 a 40 libras de 9,0 a 18 kgInstalación Orientada Hacia Atrás CON Latch Anclaje Aperturas Toallas Instalación Orientada Hacia Delante CON Latch Anclaje Aperturas Jale para Apretar Advertencia Anclaje Barra de Almacenaje Aperturas Advertencia Anclaje Barra de Aperturas Jale para ApretarModelos de 5 puntos solamente Colocar AL Niño EN EL Asiento DE SeguridadCompruebe el sistema del arnés Modelos con barra protectora solamenteModelos Operaciones Y Ajustes Jale El cinturón LevanteVertical Reclinada Para niños más grandes Modelos de 5 puntos fig. e Para bebés o niños pequeñosModelos con barra protectora fig. f Fig. e Bucle Placa de unión Fig. f SoporteGiratorio debajo De la almohadilla Del asiento Usar el sistema Latch orientado hacia atrás. o Retirar el Latch de los puntos de anclaje del vehículo Almacenaje Latch Barra de AlmacenajeCinturones DE Seguridad DEL Vehículo Cinturones ubicados delante del pliegue del asiento Pliegue del AsientoCinturones de regazo con retractor Cinturones de regazo ajustables manualmenteDéle la vuelta No SE Debe usar con ningún asiento Jale Fig. a Déle la vueltaPulgada 1 cm Almacenaje del anclaje Información AdicionalGancho del anclaje Parte trasera del asiento Para quitar el portabebidas PortabebidasDisponible en algunos modelos PestañaRetirar la almohadilla Cuidado y limpiezaRetirar la almohadilla de la barra protectora Armazón y apoyavasos de la barra protectora Asiento para autos de segunda manoLas almohadillas del asiento y de la barra protectora HebillaLista DE Piezas Cómo efectuar pedidosEnvíe a Se requieren ambos númerosLlámenos Primero