Graco ISPC008BA 08/02 manual REAR-FACING Installation with Vehicle Seat Belts

Page 14

REAR-FACING INSTALLATION WITH VEHICLE SEAT BELTS

WARNING

LATCH belt MUST be stored when

using vehicle seat belt to install car seat.

1Store LATCH belt by attaching to connectors through forward-facing openings

(see page 23, fig. k).

•Attach connectors to storage bar on each side (fig. a).

•Adjust LATCH belt to remove excess slack by pulling adjustment belt.

2Adjust car seat to recline position (see page 18 and 19, fig. b) and place rear-facingon vehicle

seat.

3Thread vehicle seat belt through openings and buckle belt.

4Press down firmly in center of car seat to compress vehicle seat cushion while tightening vehicle seat belt (fig. b).

5Pull front to back and left to right to check for secure installation (fig. c). Vehicle lap belt MUST stay tight.

If not secure, see “Vehicle Seat Belts” page 26.

6Check level indicator on car seat.

Vehicle must be on level ground and

child in car seat when checking level indicator.

Ball MUST be entirely in green zone (fig. d). If necessary, place rolled towels under car seat, at vehicle seat crease, until entire ball is in green zone. Then re-check level indicator.

DO NOT use tether rear-facing. Tether must be stored (see “Tether Storage” page 32).

Periodically check that car seat is securely installed and properly leveled; adjust if necessary.

12

Image 14

Contents Avoid injury or death Table of Contents Registration Information Safety First Check ListImportant Information Do not use rear-facing child Replaced. do not use it again! a Vehicle Seat Protection Basic InformationCertification Unoccupied Car Seat Warm WeatherWhat is LATCH? Latch System Vehicle Top Tether Anchor Point Car Seat Lower PointsOutgrowing Car Seat Height & Weight LimitsPreterm or Low Birth Weight Infants Rear-facing 5 to 30 lbs .6 kgREAR-FACINGINSTALLATION with Latch Fig. e Fig. dFORWARD-FACING Installation with Latch FORWARD-FACING Installation with Latch Tether Openings Pull to tightenREAR-FACING Installation with Vehicle Seat Belts Storage Bar Openings Towels Tether FORWARD-FACING Installation with Vehicle Seat Belts Openings Pull to Tighten StandPoint Models Only Placing Child in CAR SeatCheck harness system Overhead Shield Models OnlyPlacing Child in CAR Seat Harness Straps fig. a Point Crotch Strap Adjustment fig. cOverhead Shield Adjustment fig. d Harness TieRecline Clip Upright LiftPull Belt For Toddlers Changing Harness Strap SlotsPoint Models fig. e For Infants or Small Toddlers Overhead Shield Models fig. fPlate LoopSplitter Belt Latch Belt RoutingLatch belt. fig Under seat padRear-facing Forward-facingRemoving Latch from Vehicle Anchor Points Fig. lLatch storage Fig. p or qVehicle Seat Belts Vehicle Seat Belts Belts Forward of Seat CreaseFlip Lap Belts Manually AdjustableLap Belts With Retractor Passive Restraint Lap Belt with Motorized Shoulder Belt Passive Restraint Lap or Shoulder Belt Mounted on DoorPull Combination Lap/Shoulder Belt with Sliding Latch PlateCombination Lap/Shoulder Belt with Locking Latch Plate Locking Clip For storage of tether hook Additional InformationTether Storage Tether Hook Back of Car SeatRemoving Cup Holder Cup HolderAvailable on some models TabRemoving Overhead Shield Pad Care & CleaningRemoving Seat Pad Harness Straps and Latch belt Aircraft UseSeat Pad and Overhead Shield Pad Shell and Overhead Shield Cup HolderParts List How to OrderShip to Both Numbers RequiredCall US First Manual de instrucciones Información especial Tabla DE ContenidoUtilización Lista de control de seguridad Información ImportanteInformación de registro Advertencia Prevenga lesiones graves o la muerte Orientación trasera debe nivelarse Advertencia Información BásicaAnclaje ¿QUÉ ES EL LATCH?Sistema Latch para vehículos Sistema Latch El sistema LatchLímites DE Altura Y Peso De 20 a 40 libras de 9,0 a 18 kgInstalación Orientada Hacia Atrás CON Latch Anclaje Aperturas Toallas Instalación Orientada Hacia Delante CON Latch Anclaje Aperturas Jale para Apretar Advertencia Anclaje Barra de Almacenaje Aperturas Advertencia Anclaje Barra de Aperturas Jale para ApretarModelos de 5 puntos solamente Colocar AL Niño EN EL Asiento DE SeguridadCompruebe el sistema del arnés Modelos con barra protectora solamenteModelos Operaciones Y Ajustes Vertical Reclinada LevanteJale El cinturón Modelos con barra protectora fig. f Modelos de 5 puntos fig. e Para bebés o niños pequeñosPara niños más grandes Fig. e Bucle Placa de unión Fig. f SoporteGiratorio debajo De la almohadilla Del asiento Usar el sistema Latch orientado hacia atrás. o Retirar el Latch de los puntos de anclaje del vehículo Almacenaje Latch Barra de AlmacenajeCinturones DE Seguridad DEL Vehículo Cinturones ubicados delante del pliegue del asiento Pliegue del AsientoDéle la vuelta Cinturones de regazo ajustables manualmenteCinturones de regazo con retractor No SE Debe usar con ningún asiento Jale Fig. a Déle la vueltaPulgada 1 cm Gancho del anclaje Parte trasera del asiento Información AdicionalAlmacenaje del anclaje Para quitar el portabebidas PortabebidasDisponible en algunos modelos PestañaRetirar la almohadilla de la barra protectora Cuidado y limpiezaRetirar la almohadilla Armazón y apoyavasos de la barra protectora Asiento para autos de segunda manoLas almohadillas del asiento y de la barra protectora HebillaLista DE Piezas Cómo efectuar pedidosEnvíe a Se requieren ambos númerosLlámenos Primero