Kidco G70 manual Assembly Installation, 10a

Assembly

Installation

9.

H

	I
10.	10a.

Remove hinge cap (H) from bottom of original end section. A screwdriver may be needed to pry it off. Place under bottom hinge. Remove plastic cone from under top hinge of original end section. Install cone (I) under top hinge of new end section.

Reinstall a removable, vertical bar. Insert bar by pressing it into upper hinge cone, while sliding bar into groove of lower hinge. Spring in cone will make bar lock in place.

Proceed to ”Installation” steps 13 to 23.

13.

14.

A

A

B

Installing the wall mountings:

Fold wall cover (A) around vertical bar at end of gate.

Insert lock fitting (B).

	11.	Adding optional section/s:	15.
		Remove vertical bar from optional section
		(steps 5 & 6).
		Position optional section with cone hinge at
		top. Align cone hinge underneath top hinge
		on end section. When the center of both hin-
		ges are aligned, top and bottom, they will fall
		together.
		Insert removable bar (see step 10).
		If adding more than one section, repeat the
		process.
		Reattaching end sections:
		Align top cone corner of one section with the	16.
	12.	top hinge of the end section. When the cen-
		ter of both hinges are aligned, top and bott-
		om, they will fall together.
		Insert removable bar.
		Proceed to ”Installation” steps 13 to 23.
		Note: The HearthGate™ cannot be com-
		pletely folded when optional section/s have
		been added.
		Relocating the walk through door section:
		The walk through door section can be repo-
		sitioned in the configuration as long as it is
		interchanged with a section that has
		matching top and bottom hinges (refer to
6
		diagram 3).

	Insert 3 wall cover screws (E) through oblong
F	holes in top, middle and bottom of assembly.

Note: Loosely screw on nuts (F), but do not tighten at this time.

E

Fasten wall plate (C) onto assembly. See steps 17. a, b and c.

C

7