Installation
Installation
17. |
|
|
| Center buttons of assembly with wall plate | 21. | |
a | b | c | holes (17. a). When aligned, push buttons | |||
|
| |||||
| through holes and slide down to lock (17. b |
| ||||
|
|
|
| & c). |
| |
Buttons |
|
|
|
| ||
|
|
|
|
| ||
|
|
|
|
|
|
18. | Now it should look like this. | 22. |
|
|
|
21a.
C
D 
C
Remove wall plate (C) from assembly by pressing locking tab (21a.) and lifting it off.
Note: Screws provided are for mounting directly into wood. If mounting into brick, drywall or other surfaces, use appropriate hardware.
Hold wall plate (C) inside outline and screw in 3 wood screws (D). Space screws evenly. There are multiple holes in wall plate giving many screw location options.
Reattach assembly to wall plate (see 17. a, b and c).
19.
20.
min. 20”
20a.
Move HearthGate™ to desired location.
Warning: A distance of a minimum of 20” from source of heat/fire to gate is recom- mended (see ”Important Notes” page 2). If this is not possible with sections included, optional 24” sections are available from your HearthGate™ dealer or KidCo.
Slide the assembly as close to cone as pos- sible (20a.). With a pencil, outline assembly on mounting surface.
23.
24.
Tighten 3 sets of assembly screws and nuts.
Now you are ready to mount other end of HearthGate™. Follow steps 13 to 23.
8 | 9 |