Meyer 9122, 9130T, 9128, 9126, 9136T, 9124 manual Gate Delay Package, #8100-Gate

GATE DELAY PACKAGE

(#8100-Gate)

GATE DELAY ADJUSTMENTS

When the gate is completely closed (Tight to rear upright) cable and eyebolt assembly should be adjusted so cable has no slack. Cable should be tight but not overtightened. If cable and eyebolt is overtightened lower cylinder will trip out of the L-shaped slot on the lower bracket too soon and the gate will try to close before the cylinder is stroked out. If the ca- ble and eyebolt is too loose the lower cylinder will not trip out of the L-shaped slot and the cylinder will reach its maxi- mum stroke and the gate will still not be in the closed position. The gate will be held open by the top cylinder bracket and the bracket may become damaged over time. Eyebolt and cable will need to be adjusted periodically to maintain proper operation.

KEY	PART NO.	DESCRIPTION	KEY	PART NO.	DESCRIPTION
1	55-0095	1/8" to 3/8" NPT Reducer	11	952-0007-	7-1/4" Nylon Tie Strap
2	30-0015	1/4x90 Degree Elbow		1
3	25-8095	Oil Reservoir Assembly	12	25-8098	Cable/Eyebolt Assy.
4	55-0097	3/8 to 3/8" Hydraulic Nipple	13	25-8097-1	Lower Sleeve Spacer
5	55-0094	Flow Control Valve	14	25-8093-1	Lower Shaft Plate Assy.
6	55-0096	3/8 NPT x 90 Degree Male Pipe	15	25-8095-6	Top Copper Line Assy.
		Elbow	16	25-8101	Ground Control Rod Assy.
7	25-8096	Gate Release Trip Arm Assembly			W/Grip
8	25-8092-1	Gate Regulator Top Shaft Assy.	17	51-0007	Handle Grip
9	25-8090-1	Top Cylinder Bracket Assy.	18	933-3804	5/16 x 4” Eyebolt
10	55-0093	Hydraulic Cylinder	19	825-25-1Z	1/4x1" Self Tapping Screw

8100 Rear Unload --37--