Preh MC25-35\ manual DOS Programmer

Page 14

Figure 12

4.Repeat the same process as in point 3 for “Terminator”.

5.Click OK, and then go to File>UpdateKeyboard. Wait until programming is completed.

DOS PROGRAMMER

1.Connect your keyboard and start DOS programmer.

2.Go to the File menu and select “Read keytable”. This command will read all data and settings that are inside the keyboard. Please, make sure that the keyboard is connected. A status bar will show you when the reading of the keyboard has been completed as shown in figure 13

Figure 13

14

Image 14
Contents Page Index Computer indicates Keyboard error during start-up or booting There was an error in the checksum Keyboard does not respond, and there is no output MSR cannot be read with my software HOW to Reset Preh Keyboards Page HOW to Change the Output Speed of the Keyboard WinprogrammerDOS Programmer Page Page HOW to Change the Settings of the MSR DOS Programmer Page HOW to Remove Online Programming Go to EditHotkey Page Page HOW to Turn OFF the Unnecessary Modules DOS Programmer TRM Ver Nov