Using the Stroller as an Infant Car Seat Carrier
•To use the stroller to carry an infant car seat carrier, you must replace the Front Tray with the Car Seat Carrier Support.
•Remove the Front Tray by pressing in on the lock tabs and pulling the tray off the brackets. Store the tray in a convenient place for later use.
•Line up the female fittings on the Car Seat Carrier Support to the male fittings on the front of the stroller and push inward until the fittings snap into place.
See Figure 25. Pull outward on both sides of the support to be sure both are snapped securely in place.
•Push the canopy to its most rearward position.
•ADJUST THE SEATBACK TO ITS RECLINED POSITION.
•Remove the infant carrier from the car seat base.
•Placetheinfantcarrierontothetopofthe stroller in a REAR FACING POSITION, locating the head end of the carrier so that it rests on the Car Seat Carrier Support and the feet end of the carrier so that it rests on the seatback, but NOT on the top edge of the seatback. See Figure 26.
•Ensure that the head end of the infant carrier is pushed down firmly inside the frame of the Car Seat Carrier Support and that it is centered side to side.
•Remove the carrier restraining straps from the pouches on both sides of the
Figure 25
Figure 26
Figure 27
stroller. Buckle them in place over the LOWEST part of the carrier sides. Adjust the straps so they are tight around the carrier but AWAY from the child’s neck. Pull up on the carrier to be sure it is held on securely. See Figure 27.
•Always check frequently to be sure that the restraining straps are tight across the infant carrier but away from the child’s neck.
•When you remove the infant carrier from the stroller, always replace the two restraining straps back into their side pouches.
!WARNING
ALWAYS install the infant carrier so that the child is facing toward the rear
(handle) of the stroller with the restraining straps secured.
Page 12 | Caboose Ultralight Instruction Manual |