Cuisinart operation manual SG2-DRT-3X installed in SG2000

Page 10

10STARLINE

Figure 10 illustrates the SG2000 equipped with an SG2-RPM/C, the E-pack cover removed, the ICS locations, proper cable routing and installed SG2-DRT-3X:

Figure 10

SG2-DRT-3X installed in SG2000

ICS connections

5Install an SG2-DR-3X input board in each selected ICS location. The ICS locations on the left are for ports 1 and 3 and the locations on the right are for ports 2 and 4.

6Nest the attached cables between the components on the E-pack and toward the PIC cable and status monitoring cable (optional).

7Position the cover on the E-pack and route the cables through the bottom opening following the PIC cable.

SG2-DRT-3X Installation Sheet

Page 9 Page 11
Image 10
Page 9 Page 11
Contents Related Documentation Document Conventions Before You BeginIllustrates a block diagram of the SG2-DRT-3X Installing the SG2-DRT-3X in the SG2440 Node DescriptionIllustrates the SG2440-DR-3X return board SG2440 lid Illustrates a properly installed and cabled SG2-DRT-3X Installing the SG2-DRT-3X in the SG2000 Node Illustrates the ICS board SG2000 optical transmitter B and a locations SG2-DRT-3X installed in SG2000 STARLINE11 Specifications SG2-DRT-3X Dwdm ModelsSG2-DRT-3X Cwdm Models If You Need HelpFCC Compliance FCC Declaration of Conformity Mgbi
Top Page Image Contents