How to Play, Tips, Trouble Shooting | Excalibur electronic 9511-3

ENGLISH

To	How to Play
	begin,	insert		the	switch right and switch the
antenna wire		through		the	left switch up. If you want
hollow tube. Avoid pulling					to turn left while driving in
the wire too tight. The wire					reverse,		switch		the right
is on the top of your 1:10					switch left and switch the
Nascar® RC. Tie a knot on					left switch back.
top to secure.
Turn the switch to the ON						Tips
position for power.
In a clockwise direction,					• If your vehicle does not
screw the antenna into the					respond		to	the	transmitter,
cavity located at the top of					move closer to your 1:10
the transmitter.					Nascar® RC and try again.
Use the control switches					•	If your vehicle starts to
					lose power, it may experi-
on the transmitter®to drive					ence loss of performance. If
your	1:10 Nascar		RC. It		this happens, simply re-
will allow you to drive it					place with new batteries.
forward, reverse, left				and	•	If your		vehicle moves
right. You can also honk its					slowly,		try changing			the
horn and lift its left and					batteries		and		check	the
right doors up.					wheel mechanisms for lint,
Use both control switch-					thread, hair or dust.
es to turn. If you want to					•	When		the	transmitter
turn right while driving for-					range decreases, replace the
ward,	switch	the	right		battery in the controller. If

Changes or modifications to this unit not expressly

approved by the party responsible for compliance could

void the user’s authority to operate the equipment.

someone uses a CB nearby, it might interfere with con- trol of the car. If this hap- pens, move the car and transmitter away from the CB.

Trouble-

shooting

If your 1:10 Nascar® RC doesn’t move, please check the following potential causes:

1. The POWER switch is

turned off. If that is the

case, turn the switch

on. POWER

2. Your 1:10 Nascar® RC is too far away from the controller. If that is the case, bring your 1:10 Nascar® RC closer to the controller.

3. The metal tab in the battery cartridge is flattened and not touching the batter- ies installed. If that is the case, lift up the metal tab so it touches the tip of the bat- tery.

ENGLISH

If you lose control of your 1:10 Nascar® RC, please check the following poten- tial cause:

Another radio control vehicle using the same fre- quency is operating near your vehicle. If that is the case, you should race other vehicles that use different frequencies or channels.

If your 1:10 Nascar® RC drives slowly, please check the following potential causes:

1. There are weak batter- ies in the transmitter. If that is the case, replace with new batteries.

2. There is strong inter- ference in the surrounding area. If that is the case, you should move to a better location to drive your 1:10 Nascar® RC.