Eddie Bauer 22-750 manual Rear-Facing Must be, Belt-Positioning Booster Must be fully-upright

Page 11

4358-3410D Alpha 5pt 1/26/06 11:39 AM Page 21

1
2	A	B

Press on release button and pull apart.

For either style “A” or “B”, press red button on buckle to release the buckle plates. Place harness over sides of child restraint.

1	This child restraint has 3
1	recline positions when
	used with the base:
	upright, semi-reclined
	(Forward-facing only) and
	reclined.
	Rear-Facing - Must be
	fully reclined.
	Forward-Facing - Semi-
	reclined or upright.

Belt-Positioning Booster - Must be fully-upright.

2	To fully recline, pull out on
2	handle and push top of
	child restraint back.

For upright position, pull out on handle and pull child restraint up.

Loosen harness by pushing down on the harness release lever while pulling out on the harness. Remove child.

Pull pad off corner. Hook bottom of cup holder to edge of shell. Rotate cup holder up until tab on cup holder snaps into hole on shell. Replace pad.

Image 11

Contents Before Using Telephone Dorel Juvenile Group, IncWebsite Fax Mailing Address Box4358-3410D Alpha 5pt 1/26/06 1139 AM Dorel Juvenile Group, Inc PO Box 2609, Columbus, General and Warm Weather UseLatch Anchors Seat Buckles Air Bag Seat Bight Where seat cushions meetAnchor Bracket Pillow Front BackLbs 10.1-18 kg 34-43 in .1-110 cm and Over 1Year Old Harness Covers on select models Harness covers Check Harness/Headrest Height Rear-Facing PositionSnugly TogetherPosition harness straps over the child’s shoulders Strap to tighten harnessIs locked tightly Push each buckle plateClick. Remember to Belt-Positioning Booster Must be fully-upright Rear-Facing Must beLocking Clip section Not fix this problem. SeeAutomatic/Passive vehicle seat belts Vehicle belt too short Contact your vehicle dealer for a seat belt extenderManual Belts Steps Rebuckle belt. Lap beltPortion should now be Tight. If not, removeKg, 19-36 48-91 cm Under the base or childRestraint Any slack On belt to tighten. For aManual belt, refer to Knowing Your Vehicle16 kg, 19-36 48-91 cm Push Latch hookBelt path slot Cm, Over 1 year of age Child in child restraintChild Restraint SectionOut, then push up to lock Restraint as described Shown installedSeat and buckles, place Your child in the childWith knee still in child Restraint and push downFirmly while pulling up on Loop to tighten beltAnchorage Strap To Adjust TopLoose Latch system can result Pad. Lock buckle plates Pull harness out of shell From the front, pullBase of the childs Through oneBelt positioning guide Belt should crossBase section Reinstall BaseEnd and push bar Until it locks in placeOff the shell With one hand while pulling through the front with the otherMake sure harness guide’s tab goes over metal bar Replace seat pad by reversing orderWarranty Limitations Fax orders to

4358-3410D Alpha 5pt 1/26/06 11:39 AM Page 21

Rear-Facing - Must be

Belt-Positioning Booster - Must be fully-upright.