Eddie Bauer 22-750 manual Push Latch hook, Belt path slot, 16 kg, 19-36 48-91 cm

Page 17

4358-3410D Alpha 5pt 1/26/06 11:39 AM Page 33

4	Push LATCH hook
4	through the rear-facing
	belt path slot.

Place child restraint rear- facing in the back seat. NOTE: Tuck the top anchorage strap’s hook under the child restraint.

Rear-Facing Use: 5-35 lbs.

5

6

7

Pull other end of LATCH hook between buckle strap and rear harness slot.

Push LATCH hook through the other rear- facing belt path slot.

Put seat pad back over corners of shell.

Completed threading of the LATCH system rear- facing is shown.

2

Fasten one LATCH belt hook to the anchor in the vehicle seat located in the vehicle seat bight. Repeat for other side of child restraint. See your vehicle owner’s manual for more information.

Push down firmly on the child restraint and pull up on the loop to tighten belt.

(2.3-16 kg), 19-36” (48-91 cm)

30

31

continued on next page.

Image 17

Contents Before Using Website Fax Mailing Address Dorel Juvenile Group, IncBox Telephone4358-3410D Alpha 5pt 1/26/06 1139 AM Dorel Juvenile Group, Inc PO Box 2609, Columbus, General and Warm Weather UseLatch Anchors Seat Buckles Air Bag Seat Bight Where seat cushions meetAnchor Bracket Pillow Front BackLbs 10.1-18 kg 34-43 in .1-110 cm and Over 1Year Old Harness Covers on select models Harness covers Check Harness/Headrest Height Rear-Facing PositionPosition harness straps over the child’s shoulders TogetherStrap to tighten harness SnuglyIs locked tightly Push each buckle plateClick. Remember to Belt-Positioning Booster Must be fully-upright Rear-Facing Must beAutomatic/Passive vehicle seat belts Vehicle belt too short Not fix this problem. SeeContact your vehicle dealer for a seat belt extender Locking Clip sectionManual Belts Portion should now be Rebuckle belt. Lap belt Tight. If not, remove StepsKg, 19-36 48-91 cm Under the base or childRestraint Manual belt, refer to On belt to tighten. For aKnowing Your Vehicle Any slack16 kg, 19-36 48-91 cm Push Latch hookBelt path slot Child Restraint Child in child restraintSection Cm, Over 1 year of ageOut, then push up to lock Seat and buckles, place Shown installedYour child in the child Restraint as describedFirmly while pulling up on Restraint and push downLoop to tighten belt With knee still in childAnchorage Strap To Adjust TopLoose Latch system can result Pad. Lock buckle plates Pull harness out of shell From the front, pullBelt positioning guide Through oneBelt should cross Base of the childsEnd and push bar Reinstall BaseUntil it locks in place Base sectionOff the shell With one hand while pulling through the front with the otherMake sure harness guide’s tab goes over metal bar Replace seat pad by reversing orderWarranty Limitations Fax orders to