Mounting to the Digital Camera
yyMake sure that a DC power supply is not connected to the unit’s DC IN terminal and that the digital camera is turned off.
(Mounting or dismounting while the power is on may result in malfunction.)
1 Remove the cover for the battery grip connector and cover for the interface unit connector on the digital camera, and remove the electrical contact and interface contact caps on the unit.
yyStore the connector covers and contact caps safely to avoid loss.
yyTo protect the terminals, reattach the covers and caps after you finish using the unit. 
Terminal caps
Cover for the battery grip | Cover for the interface unit |
connector | connector |
2 Loosen the HDMI connection terminal screw (A), and slide the HDMI connection terminal out to the side.
yyDo not twist or pull the HDMI connection terminal with excessive force. Doing so may result in malfunction or damage.
3 Align the attachment screw, contacts, and camera attachment pins, and attach the digital camera.
4 Rotate the attachment screw (B) in the direction of the arrow and tighten it securely.
yVerify that the attachment screw is tightened securely during use.
(B)
5 Open the terminal cover on the digital camera, slide the HDMI connection terminal on the unit inward (toward the camera) to connect it, and tighten the HDMI connection terminal screw (A) securely.
yyOpen the terminal cover on the digital camera 90 degrees, and store it in the HDMI connection terminal.
Terminal cover
90°
(A)
Dismounting from the digital camera
yyMake sure that a DC power supply is not connected to the unit’s DC IN terminal and that the digital camera is turned off, and then perform the mounting procedure in reverse order (disconnect the HDMI connection terminal before rotating the attachment screw (B)). Performing the procedure in the incorrect order may result in damage.
10VQT5K48 (ENG)