Polaroid Polaroid Wireless Surveillance Camera, IP200 Restore Factory Settings, Reboot Device

Polaroid • Settings

3.1.4 Restore Factory Settings

Figure 5.5

Clicking on Restore Factory Settings will cause a prompt to pop-up. Select OK and the camera will return to original factory settings and the device will reboot.

3.1.5 Reboot Device

Clicking on Reboot the Device will cause a prompt to pop-up. Select OK and the device will reboot.

Figure 5.6

3.2 Network Settings

Click on Network and it will cause the prompt below to pop-up:

Polaroid • Settings

3.3 Basic Network Settings

There are two places you can manually fix the camera’s IP address. One, as we have mentioned earlier is the IP CameraTool (figure 2.3) , the other is the Basic Network Settings window below:

Figure 5.7

NOTE:The default setting for your camera is “Obtain IP from DHCP server. If you have this box checked, you will have to un-check it in order to change the IP address numbers.

If you do not know the Subnet Mask, Gateway, or DNS Server check the Local Area Connection Status of your computer. It will have all of this information. Then, do the following steps:

1.Go to Control Panel >Network Connections > Local Area Connections >Support > Details.

Figure 5.8