Polaroid IP200 user manual Mode, Brightness, Contrast, Preset Positions

Figure 4.2

Audio Buffer. Click here and window box will give you a choice of 1,2,3,4,or 5 seconds’ buffer of audio.This will prevent dropouts, clicks, or pops.

Reversal: Click here and video image can be seen reversed (up or down; this particularly important when camera is mounted on ceiling).

Mirror. Clcik to see mirror image. Click again to return image back to normal.

NOTE: Both Reversal and mirror images can be preset to remain if camera is in a special position requiring a reverse or mirror image.

Mode, Brightness, Contrast

Figure 4.3

Mode:There is an optional mode for outdoor use of the camera. It is 50Hz/60Hz. It should be noted that camera is not recommended for outdoor recording, but if it is used as such, should be set to the 50Hz setting.

Brightness. Click +- to find the up or down value of brightness you desire. Contrast. Click + - to find the up or down value if contrast you desire. Default all: Click to return to factory settings.

NOTE: If you set up the camera on the network and you receive no video and the brightness and contrast setting do not appear, you can go back to default all to achieve video feed.

Pan/Tilt

Figure 4.4

Click on and camera will pan (move from side to side) or tilt (go up or down) making at least one full pan/tilt cycle automatically.

Click to move up.You can make small incremental moves with small clicks or hold down to control the movement to the degree you wish.

Click to move down; use same methodology as Up icon.

Click to rotate camera up or down; click on to stop.

Click to rotate camera left or right; click on (SHOW ICON) to stop.

This icon activates IO output switch. Click on on/off.

PLEASE NOTE:

There are nine ways you can direct your camera.To enable this function, simply right click on live video and a translucent directional arrow will appear on the live video, then left click mouse to control the directional action.There are eight clockwise positions you can choose manually. If you click in the center, the camera will cycle through all pan/tilt directions automatically. Double click right mouse to exit function.

Preset Positions

Figure 4.5