Attach the camera
2 | Tighten the brace against |
the camera to |
secure it in place.
3
Loosen the wingnut to unlock the mounting post.
1.Attach the camera bracket to the mounting screw. Tighten it a few turns,
then turn the camera to face the direction you want.
1 | Attach the camera |
to the mounting |
screw and turn it to the desired direction.
4 | Adjust the post to |
the correct angle, |
then tighten the wingnut to lock the post into place.
2.Tighten the camera brace up against the bracket to secure it into place.
3.Unlock the mounting post by turning the wingnut to the left a few turns.
4.Set the mounting post to the correct angle, then tighten the wingnut until the post is locked into place.
Adjusting the Sun Shield
If there is too much glare in the camera, you can move the sun shield forward to provide more shade for the lens. If the top of the picture is cut off, try moving the sun shield back.
To adjust the sun shield, loosen the bolts on the side of the mounting bracket (see page 7). Slide the sun shield forward or back, then check the picture in the receiver display. When the picture is satisfactory, tighten the bolts again.