Philips EM43 manual Monitor Adjustment, Customer Support, Email Customer.Srvc@GatesHousings.com

Monitor Adjustment

The EM43 has three adjustments for hue, contrast and brightness. These adjustments can be found on the inside rear half of the housing (see photo).

While the monitor is pre-adjusted at the factory, Gates recommends the monitor be further adjusted to match the camera being used. This will ensure a consistent match between the monitor and the image actually being recorded.

Matching the camera and monitor should be done in a darkened area to allow good viewing of both the monitor and the camera electronic viewfinder (EVF).

With the camera on and the monitor plugged in, compare the image on the EVF to the monitor. Using a small Philips screwdriver, make minor adjustment to the hue, contrast and brightness on the EM43 until you are satisfied that the image on the monitor accurately reflects that being seen in the EVF.

NOTE: Hue adjustment is only applicable to NTSC SD input mode. It is not used in PAL SD or HD input modes.

Contrast

Hue

Brightness

Customer Support

If you have any questions or require further assistance with your EM43 External Color Monitor, contact your dealer or Gates directly and we’ll be happy to assist.

Email: Customer.Srvc@GatesHousings.com

Phone: 858-272-2501

Fax: 858-272-1208

Gates Underwater Products • 5111 Santa Fe Street, Suite H • San Diego, CA • 92109

858.272.2501 • 800.875.1052 • Fax 858.272.1208 • www.GatesHousings.com

7