Pelco CCC1380H-6X, MCC1380H-6 manual Eclipser Adjustment, Gray

ECLIPSER ADJUSTMENT

The eclipser function is set at the factory and usually does not need to be readjusted. However, if fine tuning is necessary, do the following:

1.Set the DIP switches.

a.AGC: OFF

b.ESC: OFF

c.BLC: OFF

2.Set the variable resistors and Eclipse DIP switch.

a.	THRE:	Counterclockwise
b.	ECLP:	Mechanical center
c.	GRAY:	Mechanical center

d.ECLP Switch: OFF

3.Set the response selector of the auto iris lens (video type) to AVERAGE. While viewing an object, set the video output level of the camera to 0.75 Vp-p (100 IRE) by adjusting the LEVEL VR of the auto iris lens.

4.While viewing a brightly lit object (Refer to Figure 2):

a.Set ECLP DIP switch to ON.

b.Adjust THRE variable resistor by turning it clockwise. Set the video output level to clip at 0.8~0.85 Vp-p.

c.Set gray level to 0.35 Vp-p by turning the GRAY variable resistor clockwise or counterclockwise.

5.While viewing an object in front of a bright background (refer to Figure 3), adjust the ECLP variable resistor by turning it clockwise or counterclockwise until the foreground is clear (sharp) and the background appears gray.

	GRAY
	BACKGROUND
GRAY LEVEL	0.8~0.85 Vp-p
0.35 VP-P
v
Figure 2. Gray Level Setting	Figure 3. Image on Monitor

C1963M (8/04) 13