Location and Function of Parts

CAMERA MOUNT

ADAPTER

	4	5	6
		LENS	VIDEO
	LEVEL
	OFF	ON	LL
10	AGC	AWB	UP DOWN
10	BLC	GAM	7
	ESC	SYNC
	ECLP	FL

DC12V

THRE ECLP GRAY

24VAC GND

9 8

1 2 3

TOP/FRONT VIEW

BACK VIEW

Figure 1. Location and Function of Parts

Lens Mount

The camera has a standard CS lens mount but can use a C-mount lens when a C/CS-mount adapter is installed between the lens and camera.

Back Focus Lock Screw

Loosen the locking screw to adjust the back focus. Back focus adjustment has been set at the factory to the standard CS-mount back focus distance. Do not loosen the back focus locking screw unnecessarily. Refer to the section on Back Focus Adjustment for instructions on how to adjust back focus length.

Camera Mounts

Mounting points are provided on the top and bottom of the camera. Maximum thread length is 3/16-inch. Attach the camera mount adapter to extend thread depth to a standard 1/4-inch.

Level Adjuster

Controls the video output level when using a DC-controlled auto iris lens.

Lens Connector

Four-pin DC-control connector for auto iris lenses. Refer to the section on Auto Iris Lenses in this manual for pin connections.

Video Output Connector

Refer to the section on Connections for instructions for how to connect a coaxial cable to the BNC video output connector.

LL – Vertical Phase Adjustment

Use these switches to adjust the vertical phase to eliminate vertical roll when multiple cameras are connected to the same power supply. Refer to the section on Camera Synchronization in this manual for instructions on how to synchronize cameras.

6	C1963M (8/04)