Pelco C458M-B operation manual CAMERA/LENS Installation, Adjustments

3.3 CAMERA/LENS INSTALLATION

Install the camera/lens you have selected for use with the IDS14 series dome as follows:

1.Loosen the 1/4-20 lens support fastener (item 1 in Figure 3) and slide lens support down.

2.Attach camera/lens to the tilt table with the 1/4-20 x 3/4" bolt, flat washer, and lock washer (items 2 in Figure 3) that are provided.

If the camera/lens can be balanced on the tilt table, the life of the dome drive will be extended.

3.Now slide the lens support up to the lens and, if applicable, fasten with the 1/4-20 x 1/2" bolt, flat washer, and lock washer (items 3 in Figure 3) that are provided.

4.Connect camera power spade lugs, coax video cable and lens connector, paying special attention to the routing of your cabling so as not to interfere with the camera/lens swing.

Proceed to Section 3.4, ADJUSTMENTS.

3.4ADJUSTMENTS

1.Turn on the power. If, the unit has an integral receiver/driver, it will begin to move in about 15 seconds and go through its start-up routine.

2.Refer to the manual for the camera/lens to set the switches on the camera as required for your application.

(2)

(3)(1)

Figure 3. Attaching Camera/Lens to Tilt Table

Pelco Manual C458M-B (1/98) 11