Pelco C3427M-D (2/09) manual Camera Positioning, Positioning the Camera

Page 25

Camera Positioning

Rotate and tilt the camera module to position the camera. Then tighten the tilt screws (axis ìin Figure 14).

NOTE: Do not over-rotate the module. Excessively turning the module in one direction could result in damage to the wiring.

ìTilt 80° (20° to 100°)

îPan 360°

ïRotation 360°

Figure 14. Positioning the Camera

C3427M-D (2/09)

25

Image 25

Contents IS150 Series Camclosure Page Contents List of Illustrations Radio and Television Interference Regulatory NoticesModels DescriptionQty Description Parts ListShown Actual Size Unshielded Twisted Pair UTP Video Cover and Back Box InstallationFixed CEILING/WALL Suspended Ceiling 4S Deep Electrical BOX Deep Electrical Box InstallationModule Removal Camera ModuleBack Box Connectors Camera Orientation Module InstallationVarifocal Lens Zoom and Focus Adjustments Camera AdjustmentsAdjusting the Focus Switch Settings DN/CH Series AdjustmentsAuto Iris Level Adjustment Vertical Phase Adjustment DAY/NIGHT Operation SW1-2 Line Sync DW/CW Series Wide Dynamic Range AdjustmentsSW1-4 Auto White Balance/Manual White Balance SW1-8 Day/Night Operation DW models only Auto Iris Level Adjustment Positioning the Camera Camera PositioningInstall Liner and Trim Ring Service Connector Attaching the 2.5 mm Monaural Headphone Plug General SpecificationsCAMERA/LENS Product Warranty and Return Information