Install Liner and Trim Ring
1.Adjust the liner (if installed), refer to Figure 15:
a.Align the screw holes in the trim ring with those in the back box to identify the proper liner position.
b.Loosen the three Phillips screws located in the trim ring.
c.Insert the blade of a standard screwdriver in one of the adjustment grooves. Rotate the liner to position the viewing window over the camera lens.
d.Tighten the three Phillips screws to lock the liner in place.
ADJUSTMENT
GROOVE
LINER
LOOSEN SCREWS
Figure 15. Adjusting the Liner
2.Place the trim ring onto the back box.
3.Tighten the tamper-resistant screws through the trim ring into the back box. Use the 1/8-inch hollow screwdriver bit (supplied).
NOTE: The screws are installed at an angle.
26 |