Pelco 90 manual Important Safety Instructions, Regulatory Notices

Page 5

Important Safety Instructions

1.Installation and servicing should be done only by qualified service personnel and conform to all local codes.

2.Unless the unit is specifically marked as a NEMA Type 3, 3R, 3S, 4, 4X, 6, or 6P enclosure, it is designed for indoor use only and must not be installed where exposed to rain and moisture.

3.Use only installation methods and materials capable of supporting four times the maximum specified load.

Regulatory Notices

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1)this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

RADIO AND TELEVISION INTERFERENCE

This equipment has been tested and found to comply with the limits of a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However there is no guarantee that the interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and the receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

You may also find helpful the following booklet, prepared by the FCC: “How to Identify and Resolve Radio- TV Interference Problems.” This booklet is available from the U.S. Government Printing Office, Washington D.C. 20402.

Changes and Modifications not expressly approved by the manufacturer or registrant of this equipment can void your authority to operate this equipment under Federal Communications Commission’s rules.

This Class B digital apparatus complies with Canadian ICES-003.

Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.

C2462M-D (3/08)

5

Image 5
Contents Series Camclosure Indoor Integrated Camera System Page Contents List of Illustrations Regulatory Notices Important Safety InstructionsQty Description Parts ListDescription Remove the Dome Bubble How to Remove the Dome BubbleVoltage Red Wire Black Wire Install the Back BoxInstallation to Surface of a CEILING/WALL Ceiling/Wall Installation IN-CEILING Installation Suspended Ceiling How to Remove Surface Mount Ring from Back Box In-Ceiling Installation to a Fixed Ceiling/Wall IN-CEILING Installation Fixed CEILING/WALL24 VAC Installation to the Surface of a 4S Standard Electrical BOXDeep Electrical Box Installation Installation in a 4S Deep Electrical BOXPositioning the Camera Camera PositioningALC/ELC switch Always ELC DC switch Not used Camera AdjustmentsSwitch Settings Adjusting the Phase Control Vertical Phase Adjustment 24 VAC Operation onlyDome Liner Installation Reinstall the Dome BubbleInstalling the Dome Bubble Dome Bubble InstallationConnecting the Monaural Headphone Plug to the Coaxial Cable Service ConnectorBackbox SpecificationsPage Product Warranty and Return Information ISO9001