JAI TM-6760 operation manual Attaching the Analog Video Output, JAI, Inc. Power Cables

Page 12

TM-6760 Series Progressive Scan Shutter Cameras

When wiring the PD-12UU power supply directly, please note the following:

•The lead ends must be twisted together and tin-soldered for strength and electrical continuity.

•Shrink tubing or a similar insulator should be used to prevent exposed leads from touching and shorting.

•The +12V lead is marked with a red stripe or white lettering; be sure not to reverse the leads.

•All connections must be properly insulated to prevent shorting.

2.2.7 (b) JAI, Inc. Power Cables

If you are using JAI, Inc. power cables such as the 12P-02S, please refer to the 12-pin connector pin-out diagram in “12-Pin Connector (TM-6760)” on page 6. The cable pin-out diagram is shown in Figure 7 below. The color-coded leads use Gray for Ground and Yellow for +12V.

FIGURE 7. 12P-02S Interface Cable (optional)

		+12 V
	GND (Gray)
Jack	Power (Yellow)
	Video Out (Red Coax)		}
	HD In (White Coax)
	VD In (Black Coax)

Monitor

Analog

Frame Grabber

12P-02S Interface Cable

Pin#	Lead Color	Function	Pin#	Lead Color	Function
1	Gray	GND	7	Black coax	VD Input
2	Yellow	+12V DC	8	White coax shield	Reserved
3	Red coax shield	GND	9	White coax	HD Input
4	Red coax	Video	10	Brown	RXD
5	Orange coax	GND	11	Blue	Integration
	shield
6	Orange coax	VINIT IN	12	Black coax shield	TXD

Note: Make sure that the unused leads are not touching and that there is no possibility that exposed wires could cause the leads to short.

2.2.8Attaching the Analog Video Output

When connecting the TM-6760 to an analog framegrabber or a monitor, use the BNC connector on the rear panel of the camera. The input of the monitor should be balanced for 75 ohm termination. Standard RG-59 type coaxial cable should carry a full video signal for up to 100 feet.

The multi-conductor cable 12P-02S from JAI, Inc. can be used to transmit analog video, power, sync. signals, and serial communication. The mini coaxial leads in JAI, Inc. multi-conductor cables are designed for short runs of no longer than 100 feet.

Note: Make sure that no extraneous wires are visible which could cause a short.

Installation