JAI CV-M30 operation manual Locations and Functions

Page 4

CV-M30

4. Locations and Functions

Fig. 1. Locations

1.1/2” interline-transfer type CCD sensor

2.Lens mount for C-mount lenses. *1)

3.BNC connector for video output

4.Switch block SW1 for shutter speed and function mode setting

5.6-Pin connector for Input/output of control signals

6.12-Pin connector for 12V DC power and external sync signals

7.Gain potentiometer for manual gain adjustment

8.Screw holes for Tripod mount plate. (Screws 3.0 x 5mm)

9.Tripod mount plate to place the camera on a tripod

Note *1):	Rear protrusion on the C-mount lens must be less than 10mm (0.4 inches approx.).
	When IR-cut filter is used, it must be less than 7.0 mm (0.28 inches approx.).
	The IR-cut filter is placed in the C-mount thread.
	The C-mount IR-cut filter must be ordered separately.

- 3 -

Image 4

Contents CV-M30 Table of Contents Standard Composition Main Features GeneralLocations and Functions Pin Multi-connector Trigger Pin Multi-connector DC-IN/VIDEO OUT, EXT.HD/VDPin Assignment Input and Output Diagram WEN and EEN outputFunctions and Operations Input of External HD/VD SignalsContinuous Operation Edge Pre-select Mode Pulse Width Control Mode Partial Scanning Mode Double Speed ModeOther Functions External Sync Mode External Sync Mode. Partial ScanEdge Pre-select Edge Pre-select. Partial ScanPulse Width Control Pulse Width. Partial ScanMode Setting Switch SW1 on Rear PanelTrigger Mode Scan Mode SettingsGain Setting Switch Internal Switch and Jumper Settings Internal Adjustments of Video Signal Internal adjustments positionsExternal Appearance and Dimensions OutlineSpecifications Specification tablePrecautions Typical CCD CharacteristicsAppendix SmearUsers Record Declaration of Conformity